澳门银河赌场注册送38-澳门银河赌场招人好招吗_百家乐德州_全讯网下载 (中国)·官方网站

Abstract: In extended-reach or long-horizontal drilling, cuttings usually deposit at the bottom of the annulus. Once cuttings accumulate to a certain thickness, complex problems such as excessive torque and drag, tubing buckling, and pipe stuck probably occur, which results in a lot of non-productive time and remedial operations. Cuttings bed remover can efficiently destroy deposited cuttings in time through hydraulic and mechanical stirring effects. This paper aims to build a method for hole cleaning evaluation and installation spacing optimization of cuttings bed remover to improve the wellbore cleaning effect. Firstly, a Computational Fluid Dynamics approach with Eulerian–Eulerian multiphase model was utilized to investigate the mechanism of cuttings transportation, and a new type of cuttings bed remover was designed. Next, an evaluation method of hole cleaning effect of remover was established. After that, the effects of several drilling parameters on hole cleaning including flow rate of drilling fluid, rotational speed of drillpipe, rate of penetration, wellbore size, rheological property of drilling fluid, and remover eccentricity on the performance of cuttings bed remover were investigated. The results demonstrate that the new type of remover with streamline blade performs better than conventional removers. The efficiency of hole cleaning is greatly improved by increasing the rotational speed of drillpipe, flow rate of drilling fluid, remover eccentricity, and 6?rpm Fann dial reading for drilling fluid. While higher rate of penetration and large wellbore size result in worse hole cleaning. These findings can serve as an important guide for the structure optimization design of cuttings bed remover and installation spacing of removers.