澳门银河赌场注册送38-澳门银河赌场招人好招吗_百家乐德州_全讯网下载 (中国)·官方网站

Abstract: Radial well filled with phase change material has been proposed as a novel sand control method for hydrate exploitation. In order to reveal the sand control mechanism, CFD-DEM coupling method is applied to simulate the migration, settlement, and blockage processes of sand particles in the radial well. The obtained results indicate that three scenarios have been recognized for sand particles passing through sand control medium, based on the diameter ratio of sand control medium to sand particle (Dd): fully passing (Dd?=?8.75–22.5), partially passing and partially blocked (Dd?=?3.18–5.63), and completely blocked (Dd?=?2.18–3.21). After being captured by the sand control medium, sand particles can block pores, which increases fluid flow resistance and causes a certain pressure difference in the radial well. The pressure in the radial well should be lower than the hydrate phase equilibrium pressure during sand control design, for the purpose of promoting hydrate decomposition, and sand capture. The length of the radial well should be optimized based on the reservoir pore pressure, production pressure difference, bottom hole pressure, and the pressure gradient in the radial well. It should be noticed that the sand control medium leads to a decrease in permeability after sand particles captured. Even the permeability is reduced to several hundred millidarcy, it is still sufficient to ensure the effective flow of gas and water after hydrate decomposition. Increasing fluid velocity reduces the blocking capacity of the sand control medium, mainly because of deterioration in bridging between sand particles.